Fan and 80 mm Double Pulley for Hydro PMA or Hydro PMG fits 17mm Shaft

Description

YOU ARE BIDDING ON A NEW COOLING FAN AND 80 MM DOUBLE PULLEY
(For permanent magnet alternator generator with 17 mm shaft)
Pulley fits 1/2" belt.
Comes with nut and spacers
Please specify when ordering if this is for a PMA or PMG--Thank you!
This fan and DOUBLE 80 MM pulley is used on our PMAs and PMGs when using a gas motor
or hydro, a must for keeping your alternator cool.
Overheating a pmg or pma will burn it out.
NOT NECESSARY WHEN PMA PMG IS USED FOR A WIND TURBINE
Fits our Freedom permanent magnet generator and Delco 10 si pma's
(PICTURE BELOW SHOWS THE FAN AND PULLEY MOUNTED ON OUR FREEDOM ll PMG )
(PMG NOT INCLUDED)
CLICK HERE TO SEE OUR FULL LINE OF WIND AND SOLAR PRODUCTS!
We do not mark items as gifts or under report values for customs. For International buyers,
it is strongly recommended to check your own country's tax practices as we do not
pay your taxes, duty or customs fees.
We do not over charge for shipping; it is simply what the shipping calculator comes up with.
Customs fees or taxes are not included in shipping, it is your responsibility to pay them.
UPS orders shipped signature required at our discretion!! Contact us right away if you need to make other arrangements!
Products may be slightly different than the ones pictured. If our supplier runs short of the products shown, we will substitute them for the same quality or better.